TL/03

Hydraulic transients

A proper design of a pressurised hydraulic installation entails simulating its operation both in steady state and in transient regime. The analysis in steady state enables obtaining the dimensions of the system. The analysis of the transient system is necessary in order to design the right protection systems to withstand the pressure oscillations arising through handling drive and regulation items.

Person responsible for this line: Vicent B. Espert Alemany

Sorted by date Sorted by title
Papers published in specialized magazines
2010
Discussion of "Transient Flow Caused by Air Expulsion through an Orifice" by De Martino, G., Fontana, N. and Giugni, M.
Journal of Hydraulic Engineering (2010)
2005
Applied Hydraulic Transients for Hydropower Pants and Pumping Stations
Journal of Hydraulic Research (2005)
2004
Discussion of "Transient Flow in a Rapidly Filling Horizontal Pipe Containing Trapped Air"
Journal of Hydraulic Engineering (2004)
1992
Air valves and liquid length variation in hydraulic transients
(1992)
On the influence of liquid length variation in hydraulic transients
(1992)
1991
Air Vessel collapse due to a thermal gradient. A case of study
(1991)
El control de las depresiones en tuberías de impulsión. Análisis comparativo de las diferentes alternativas existentes.
Revista Tecnología del Agua (1991)
1989
El Estado actual de los transitorios hidráulicos en España. Aportaciones más necesarias para tratar de elevar el nivel tecnológico del país en este área
Revista de Obras Públicas (1989)
1986
Análisis del golpe de Ariete en impulsiones protegidas por válvulas de alivio
(1986)
The past and present of hydraulic transients in Spain. Analysis of the right way to improve the situation
(1986)
1977
Análisis simultáneo del golpe de ariete y de las chimeneas de equilibrio por el método de las características.
Revista de Obras Públicas (1977)
Cálculo del golpe de ariete en tuberías de impulsión por el método de las características
Dyna (1977)


Papers published in congresses
2009
Disipadores de energía para controlar el vaciado de conducciones
JIA, Jornadas de Ingeniería del Agua 2009 (2009)
Las ventosas como sistema de protección en el arranque de bombas de pozo
Jornadas de Ingeniería del Agua 2009. Agua y Energía (2009)
2008
Estudio de transitorios en grandes conducciones. El caso del trasvase Júcar-Vinalopó
XXIII Congreso Latinoamericano de Hidráulica. IAHR (2008)
The use of air valves as protection devices in pressure hydraulic transients
10 th International Conference on pressure surges (2008)
Transitorios en estaciones de bombeo en sistemas de drenaje urbano
Jornadas Iberoamericanas sobre el riesgo de inundación en zonas urbanas. Medidas correctoras (2008)
2005
Hydraulic Transients Generated by Bursts in a Great Length Pipeline and Study of its Protection System Using air Valves and Automatic Valves
8th International Conference on Computing and Control for the Water Industry (CCWI 2005) (2005)
2004
High Performance Water Meters. Are They a Cost-Effective Alternative?
Water & Wastewater Europe (2004)
2003
Air valves dynamic behaviour
Pumps, Electromechanical Devices and Systems Applied to Urban Water Management (PEDS) (2003) 368KB
Coupling between well hydraulics and pump operation to determine unsteady flowrates
Pumps, Electromechanical Devices and Systems Applied to Urban Water Management (PEDS 2003) (2003)
2000
Transient Analysis and Water Hammer Protection
Hydraulic Machinery and Systems.20th IAHR Symposium (2000)
1996
Analise de transitorios em sistemas complexos. Exemplos
VII Encontro Nacional de Saneamento Básico (1996)
Generalization of pump station boundary condition in hydraulic transient simulation
XVIII IAHR Symposium of Hydraulic Machinery and Cavitation (1996)
Project ADAPT - AGUA: An example of Continuing Professional Development Programmes and its linkages with PhD programmes
Workshop on Interdisciplinary PhD programmes: Dream or Reality. (1996)
Regimes transitorios em conductas elevatorias. Parte II Metodología aproximada baseada no modelo rigido
VII Encontro Nacional de Saneamento Básico (1996)
Regimes transitorios em condutas elevatorias. Parte I Modelo elástico versus modelo rigido
VII Encontro Nacional de saneamento Básico (1996)
Simulación mediante ordenador personal de transitorios hidraulicos en sistemas simples
VII Encontro Nacional de Saneamento Básico (1996)
Transitorios hidraulicos en sistemas simples. Tests y ejemplos
VII Encontro Nacional de Saneamento Báscio (1996)
1992
Influence of trapped air pockets in pumping systems
Hydrosoft (1992)
Transitorios hidráulicos en emisarios submarinos protegidos por ventosas. Comparación entre modelos elástico y rígido
XV Congreso Latino Americano de Hidraulica (1992)
1991
Boundary between elastic and inelastic models in hydraulic transients analysis with entrapped air pockets
(1991)
1990
El control de las depresiones en tuberías de impulsión. Análisis comparativo de las diferentes alternativas existentes
XIV Congreso Latino Americano de Hidraulica (1990)
1988
Development of a computer programme for the calculus of water hammer protection devices by sensitivity analysis
Computer methods and water resources (1988)
Establecimiento de un método para la evaluación de la eficacia de un volante de inercia como elemento protector antiariete basado en un analisis sensitivo del problema
XIII Congreso Latino Americano de Hidráulica (1988)
1986
Calculus of water hammer's protection devices by sensitivity analysis. Application to the flywheel
International Conference on Computer Aided Design (CAD) in Hydraulic and Water Resources Engineering (HYDROCAD) (1986)
1985
Aplicación del análisis sensitivo al dimensionado de elementos protectores del golpe de Ariete. Aplicación al volante de inercia
IV Coloquio de Turbomáquinas (1985)
Ponencia
IV Coloquio de Turbomáquinas (1985)
1984
Determinación del caudal de equipamiento de una microcentral hidroeléctrica de agua fluyente.
XI Congreso Latinoamericano de Hidráulica (1984)
1982
El flujo turbulento de los fluidos. El problema del cierre. Introducción a las técnicas de resolución de los mismos
Jornadas de motores térmicos. Proceso de renovación de la carga (1982)